ArcShape Properties

The ArcShape type exposes the following members.

Properties
  NameDescription
Public propertyBlendMode
The blend mode used by this shape. (default is BlendMode.Inherit)
(Inherited from ContentShape.)
Public propertyBrush
The brush that is used to fill this shape if closed.
(Inherited from PathShape.)
Public propertyCenterX
X-position of the center of the arc.
Public propertyCenterY
Y-position of the center of the arc.
Public propertyDock
How this shape is docked.
(Inherited from Shape.)
Public propertyEndX
Calculated horizontal position of the end point.
Public propertyEndY
Calculated vertical position of the end point.
Public propertyID
This Identifier (ID) can be used to track which shape raise an exception.
(Inherited from Shape.)
Public propertyMargin
Get or set the margin of a shape.
(Inherited from Shape.)
Public propertyOpacity
The opacity (0...255) which must be used for this shape. Default is 255 (fully opaque).
(Inherited from ContentShape.)
Public propertyPen
Used to draw the curves on this path.
(Inherited from PathShape.)
Public propertyRadiusX
Horizontal radius.
Public propertyRadiusY
Vertical radius.
Public propertyRenderingIntent
Gets or sets the rendering intent (default is RenderingIntent.RelativeColorimetric).
(Inherited from ContentShape.)
Public propertyStart
Start angle (0 corresponds to 3 o-clock).
Public propertyStartX
Calculated horizontal position of the start point.
Public propertyStartY
Calculated vertical position of the start point.
Public propertySweep
Sweep angle, counter-clockwise.
Public propertyTransform
Apply this transformation to the content shape before rendering.
(Inherited from ContentShape.)
Public propertyX
X-position of the lower-left corner, center or start point (depending on shape type).
(Inherited from ContentShape.)
Public propertyY
Y-position of the lower-left corner, center or start point (depending on shape type).
(Inherited from ContentShape.)
Top
See Also